How to replace front wheel bearings on a 2012 kia?

Seeking Advice Forum
1

hi everyone, i’ve got a 2012 kia and need to replace both front wheel bearings. has anyone done this? i’m looking for a step-by-step guide or any tips you might have on the process. i think it’s a press-in bearing, so do i need to remove the knuckle first?

2

yup, you’ll need to remove the knuckle to press out the old bearing and press in the new one. might need a hydraulic press if you don’t already have one.

3

howdyrobert said:
yup, you’ll need to remove the knuckle to press out the old bearing and press in the new one. might need a hydraulic press if you don’t already have one.

thanks, good to know! i’ll see if i can get access to a press.

4

if you haven’t done this before, it can be a bit tricky. make sure to mark everything so it lines up when you reassemble.

5

watch out for the snap rings—they can be stubborn to remove. a set of snap ring pliers will help a lot.

6

SophyGenesis said:
watch out for the snap rings—they can be stubborn to remove. a set of snap ring pliers will help a lot.

appreciate the tip! i’ll make sure i have the right tools.

7

double-check the torque specs for when you reinstall everything. it’s important to keep it all tight to avoid any issues down the road.

8

hope it goes smoothly. getting those bearings pressed in can be a challenge, but it’s doable. good luck!